Peugeot 406 ST wont start Helppp !!!!

Discussion in 'Peugeot 406' started by Dushee001, Dec 27, 2012.

  1. Dushee001

    Dushee001

    Joined:
    Dec 27, 2012
    Messages:
    1
    Likes Received:
    0
    Went to work this morning as usual. Tried starting car after work
    engine turns over but doesnt start
    The airbag light , check engine light and immobiliser light stays lit .
    towed the car to a garage and had them run a diagnostic
    these are the codes i got
    code1:
    intermittent fault.battery
    charge.
    Code2:
    intemittent fault.absence of BSI
    commnication with the CAN
    network ECUs.
    Code3:
    permanent fault.absence of
    communication with the engine
    management ECU.
    Code4:
    permanent fault.remote
    permanent fault.vehicle
    longitudinal acceleration
    information.incorrect value
    received.
    Code5:
    Remote permanent fault.coolant
    temperature infirmation.incorrect
    value recieved.
    Code6:
    remote permanent fault.vehicle
    speed information.incorrect value


    As the mechanic suggested we swapped the fuse box in the engine bay. and the car started up fine with no faults. but after running for about 30 minutes the car stopped again and showed the same problem. swapped the bsm again with a working one and th same thing happened.

    Any suggestions on where i should look for the problem?????
     
    Dushee001, Dec 27, 2012
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.