non starting 406 hdi

2000 406 hdi car wouldnt startbut after turning engine over 4 about 30
seconds would start.this went on 4 about a week,now car wont start at
all. had car diagnosed at local garage and they said the high presure
pump was at fault, so had that changed car now starts up straight away
but stalls after 10 seconds some times will run 4 30 seconds. car
starts up straight away each time have. have changed the fuel relay by
the ecu also since the new pump has been fitted if u turn the car of
when its running it doesnt stop until the key is taken out has any 1
got any ideas. have also changed the camshaft sensor. when u plug it
into the computor it says fuel rail pressure have also changed fuel
rail sensor, i need help

 

Sorry to hear about your ordeal , my advice take it to a main dealer perhaps
goodfellowsgarage walsall west mids if you are local to that area .yes main
dealers can be expensive ,but this is a good example that its better to pay
one bill of a said amount than x20 £50 from fred from the shed.. all the best
mark

 

It sound as if the lift pump in the tank might be causing problems. I agree
with Mark B that you need to get it properly diagnosed.

 

i'd rather look at the stop solenoid,


I agree

diag 2000 is one way to go....

 

It hasn't got a stop solenoid mate its h.d.i remember!.