Heater matrix pipes?

Discussion in 'Peugeot 406' started by davea, May 31, 2014.

  1. davea

    davea

    Joined:
    May 31, 2014
    Messages:
    1
    Likes Received:
    0
    Hello. New to the site so go steady. I have a 406 hdi y reg. Apart from needing a service the car runs lovely. then i go a water leak. It was leaking at the point where the metal heater matrix pipe comes into the engine bay and joins a rubber pipe with a air bleed point. I have so far changed the rubber pipe with no success.

    Have found a useful you tube video on how to get to the heater matrix without taking the whole dash out.

    So my question is.

    Is it likely the metal pipe is a fault?
    Once i have access to the heater matrix in the car, is it easy to remove the metal pipe and replace.

    Thanks

    Dave
     
    davea, May 31, 2014
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 306 heater matrix

  2. Clogged heater matrix

  3. Does heater matrix need replacing?

  4. 405 heater matrix

  5. 406 Heater matrix - much of a job?

  6. HEATER Matrix - How do I remove the Tubes?

  7. 306 Heater Matrix bypass: Do I cut the pipes and use (what size?) copper pipe?

  8. K Reg 405 1.8 petrol estate heater matrix

Loading...