Fog Lights 306 T/D

I'm racking my brain trying to figure out how to replace a front bulb to
a front fog light on my 306 T/D Meridian.

Can anyone advise me on how to get to the bulb.

Thanks very much

 

Mark wrote in message ...

If they are like the ones on my 405, you need to take out some torx screws
from the front of the bumper, and then withdaw the whole lamp assembly. It
is not unusual to find the connector has corroded. The bulb normally has a
wire connected to it - H3 type.

hth

Bob

 

Thanks very much for the reply Bob - will be trying to locate screws at
first light !!

 

I worked out on mine that you have to attack from behind and below, by
removing the horizontal weathershield between the corner of the bumper and
the main wheel arch shield. It's held by three torx screws. That's as far
as I got because I was beginning to solidify. When the weather is a bit
warmer I'll have another go, this time raising the front end on stands to
give me better access.

It looks as though having removed the shield, you then remove the screws
(two?) retaining the light unit and withdraw it from the space behind the
bumper. My failed lamp is the nearside. I might have to move the horn to
get the lamp out.

Peter

 

Why wait till its light?? can always use a torch to see what you are doing.
from chris Addlestone Surrey

 

Thanks Peter - sounds like intensive surgery tomorrow.
I kinda hope it doesn't rain again all day tomorrow !!