Airbag Warning Light on drivers seat

[riber3]

Hi everyone
I am hoping to get some advice on a 206 drivers seat that has been replaced. I want to fit a resistor to bypass the airbag warning light on the dash.
There are 2 connector plugs fro the loom. One is a green 3 pin and the other is a White 2 pin which I assume is for the airbag and If I am correct this is where I need to fit a resistor.?

 

[riber3]

Are there any tech guides I can follow to do this with? I have looked a couple of youtube videos but they are not great

 

[riber3]

Is it just a case of soldering or connecting wires together without a resistor as mentioned in other posts? I am starting to feel a little lonely out here lol!!