406 hdi 90 non starter

Discussion in 'Peugeot 406' started by jim34, Feb 16, 2006.

  1. jim34

    jim34 Guest

    Hi
    Can any one shed some light on this one, car will not start off the key
    will only start when easy start sprayed in, runs fine then will cut out
    when pushed hard and at same time message comes up air pollution fault,
    only way to get it running again is use east start, so far we have put new
    pump in tank, new crank sensor also no faults on snap on scan tool plus we
    have ecu checked, also noted was infrequent pulse at injectors when
    cranking.
    regards jim34
     
    jim34, Feb 16, 2006
    #1
  2. jim34

    davek Guest

    Possible air leak into fuel system.
    DaveK.
     
    davek, Feb 17, 2006
    #2
  3. jim34

    MARK B peugeot m.t. via CarKB.com Guest

    Sounds like a possible high pressure pump problem.This system needs to see a
    minimum of 120 bars to start. By spraying easy -start in ,it sounds like the
    vehicle is running off it to bring it to the min threshold.hope this helps
    mark
     
    MARK B peugeot m.t. via CarKB.com, Feb 19, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Replace head gasket diesel 1.9 non turbo

  2. 405 STi non-starter

  3. non starting 406 hdi

  4. 306 turbo diesel non runner

  5. 307 Non starter on key, but will if towed.

  6. peugeot 206 2.0 hdi starter problems

  7. Non-starter

  8. 206 hdi starter removal

Loading...