306 immobiliser

Discussion in 'Peugeot 306' started by Sharon via CarKB.com, Mar 26, 2005.

  1. Please help.

    Have a 306 XSi 3 dr N-reg,with the keypad immobiliser. When you turn the
    key, both lights come on. Tried a few of the tips on here and the
    disconnecting and reconnecting worked briefly, but now cannot get the car
    started at all. The engine turns over, so don't think it's mechanical.
    You can type in numbers, but they have no effect, although if you type in 3
    times it locks the system.

    Have read that if we get it started then we can disconnect it. Just need
    to get it started.

    Any advice?
    Sharon via CarKB.com, Mar 26, 2005
    1. Advertisements

  2. Hi

    The keypad doesnt stop the engine turning over when armed.

    Check the fuel cut off switch under the bonnet ( Black or red button bolted
    to the body )hasnt tripped, Just press it to reset it.

    Also check the 3 large wiring loom connectors behind the passenger side
    headlamp, These give a lot of trouble when the car ages & the immobiliser
    wires run through here.
    Lee Power via CarKB.com, Mar 31, 2005
    1. Advertisements

  3. Sharon  via CarKB.com

    Mindwipe Guest

    Mindwipe, Mar 31, 2005
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.