2.0 xu10 head and followers

Discussion in 'General Motoring' started by igorsd, Jul 20, 2006.

  1. igorsd

    igorsd Guest

    I have 605sli 2.0, single point mareli. (RDZ engine or XU10MZ) I can't
    locate where knocking came from (hard and loud), but the clearance
    betveen valve followers and cylinder head (not valve clearance) is to
    big. I did'n measure but there is about 1mm difference betveen
    follovers and cylinder head. Can anybody tell me dimensions of
    follovers and diameter of its hole in the cylinder head. Tolerance and
    exact diameter will bee more the good. I checked all bearrings in
    engine and it is OK. I have haynes manual for citroen XM 2.0i (same
    engine) and some other peugeot engines but that diameter is nowhere
    specified.
    Help, please :(
     
    igorsd, Jul 20, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Diesel (TUD5) Woes - Won't start after head gasket & Cam Belt change.

  2. 307 and clarion head unit???

  3. after new timing belt and head gasket, 205 won't start

  4. 306 block and head rotting........

  5. 605 XU10 oil leak

  6. Flat battery and consequent radio and plip problems

  7. 307 head gasket and water pump damage

  8. S and winter flashing and then dash appear

Loading...