Pug 405 1.9D Drop Links

Discussion in 'Peugeot 405' started by Joe King, Mar 3, 2006.

  1. Joe King

    Joe King Guest

    I`m unable to remove the upper bolts on both the front drop links.
    They appear to be siezed with the bolt head recessed into the upper
    link such that spanners/sockets are unable to sit fully down.
    Now, as I see it I have two feasible options.
    (1) cut through the rubber bushing and hope to remove the rest in situ
    (2) Completely remove the antiroll bar with/without drop links on.

    Is (2) possible with drop links still fitted ?
    Any other ideas most appreciated.

    Joe.
     
    Joe King, Mar 3, 2006
    #1
  2. Joe King

    Anthony Redshaw Guest

    Not Recessed the bolts are usually only half thickness.

    If you pull the link off the rubber you may be able to get a socket or a
    ring to fit better.

    The petrol 1.8 had a 19mm bolt for good measure.


    Peugeot strikes again

    Tony R
     
    Anthony Redshaw, Mar 3, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. pug 405 problems

  2. big wheels little drop?

  3. pug 405 1.9td overheating

  4. 206 drop linkage

  5. Revs don’t always drop?

  6. 407 worn sway bar links

  7. Key copied for pug 405 cheaper than dealer (remote built in)

  8. ECU light on Pug 405 1.8glx

Loading...